Empty running and backhaul reduction simulator

Short answer: Empty running % is empty km divided by total km. If you avoid some empty km, the new % uses the reduced total: (empty km − avoided km) ÷ (total km − avoided km). If you turn empty km into paid backhauls, the total stays the same. The simulator shows both cases and the variable cost avoided.

Two different situations

Avoided km: the truck no longer drives those km (for example, a shorter route to the next pickup). The total falls and you save the variable cost per km.

Converted km: the truck drives the same km but with paid freight (a backhaul). The total does not change and cost does not fall, but those km earn revenue. Revenue depends on the rate and is not estimated here.

Limits of the simulation

The simulator does not find loads and is not a freight exchange. You estimate the reducible km from your job history. The variable cost per km (fuel, tolls, wear) should come from your accounts. Savings are not guaranteed.

Empty running formulas
IndicatorFormulaExample (10,000 / 2,500 / 500)
Empty % beforeempty km ÷ total km2,500 ÷ 10,000 = 25%
After, avoided km(empty − avoided) ÷ (total − avoided)2,000 ÷ 9,500 = 21.05%
After, converted km(empty − converted) ÷ total2,000 ÷ 10,000 = 20%
Variable cost avoidedavoided km × variable cost per km500 × 1.20 = 600

Trip-cost calculator

Data you need

  • Total and empty km over the same period and fleet
  • A realistic estimate of reducible empty km from job history
  • Variable cost per km from your accounts
  • Avoided km kept apart from km converted into paid work

Relevant TransLogic One modules

Solutions by customer profile

Read next

The interactive calculator needs JavaScript; the formulas and worked example above work without it.

All resources · Request a demo · +40 773 547 197 · office@translogicone.com

Frequently asked questions

How do I calculate empty running percentage?

Divide the km driven without freight by total km over the same period and multiply by 100.

Why does the rate fall differently for avoided km and backhauls?

With avoided km the total also falls, so the denominator changes. With backhauls the total stays and only empty km fall.

Does the simulator find backhaul loads?

No. It is a calculation on the figures you enter, not a freight exchange, and savings are not guaranteed.